hey joel, the pipe size 1.5 and 1.25" are nominal sizes, actual ID is 1.64 and 1.44" with small variations. your 1 5/8 OD tubing is probably 0.065" wall, and therefor 1/8 total wall thickness for an id of 1.5". thats really a good balanced ID size between the two pipe sizes.

as far as the backpurge ...

got the cluster thanks

does anyone know the maximum i could skim a later head for an NA app before valveysmashy?
whats the bentley maximum?

thanks in advance

can you fit a 90deg silicone on the compressor outlet and run a bigger filter vertically oriented, tucked just inside the framerail?

i have that silicone Tee piece, you can have it for shipping if you still need it LMK via PM

Houston we have tinkering

AngryTaco wrote:Congrats on the house but the real question is....

Dafuq are the anti-lag videos?

dafuq youre 20vt?

Oh, I'm also in contract to buy a house, with closing set for the 16th! It will be strange to have a garage of my own to work in!
WHAT?! CONGRATS DAVE! That is awesome. Having your own garage is the single best tool you can have for a project car. Careful not to let the driveway get too full ...

if you are ordering custom pistons, measure youre damn block!!!!! it would suck to get customs and realize yours was skimmed

and CORRECTION per mr Hank its 236.25mm

PRY4SNO wrote:Pics or it didn't happen, lol

Let's see the Beast!

as she sits in her new home, time to open all these totes and re-assemble

Glad you are still alive
thanks, me too

Is this fucking thing done yet?!

Did you ever install the adjustable steering column?
not running yet, but finally back into it after moving twice.
and yes column is in and fully functional

Impressive as usual !!

Cheers
Thanks, how about your ...

I PM'd you my email, hit me up there, not on here too much

I have and make all the swap parts, shoot me a pm

landfill wrote:I have a stage 1 chipped urs4 ECU. LMK.

his harness jsut went out but i didnt hae an ecu for him, hes prob still looking

how much for the header and do you have the midpipe? location?

msc direct

i have an AAN harness uncut ready to go
PM'd

same as cq?

I have a 2.7tt 6spd so will I have to swap transmission side flanges to bolt to my axles?
right. From a 4kq I think. Maybe you could use 108 inner CV's on your axles as another option. Not sure, as I havent done that.
yeah 4kq trans output cups need 2.5-3 mm taken off the inside spline end and ...

[quote="DE80q"]You can also get the 100mm output flanges from the B5 rear diff. There is always the option to find the RS2 shafts as well.[/quote

i think you mean aby s2 shafts

yay i want a 6 cyl versioN!

DE80q wrote:ME! Where are they!

ill be out there by 11 and will snap a few!

i have some good urs bilstein rears

go 30 frame, have trust

yay