Where does this go? AAN

[PRY4SNO]

So I effed up, didn't label everything in a motor swap (tried to rush things) and need some help with the nitty gritty. More to come, these are a few of what is hanging me up presently.

Any help explaining where this junk goes would be greatly appreciated.


The one pin, black wire spade


The 2-pin black/brown wire one, not the 2-pin blue one off the ISV


Bracket goes where?

[ads]

http://12v.org/urs/AANEngineBaySideAnnotatedVer1.jpg

Black single pin is for 02 sensor and the black 3 pin is wss on drivers side of trans just above and behind output flange.

Not 100% on the bracket. Its on a power steering line correct?

[yodasfro]

Brackets go on the intake manifold
http://forums.audiworld.com/showthread.php?t=2851910

[PRY4SNO]

Great link Austin, I never think of AW anymore.

Huge props to Adam for the help out today. Your familiarity with the AAN really saved my bacon.

Project is progressing.

Will post follow up questions as required.

[PRY4SNO]

Two more, both driver side. One down by the AC compressor and the other in the throttle body area.

[ringbearer]

The flat one by the AC compressor should be the fan switch in the bottom corner of the radiator

[PRY4SNO]

Cool, thanks. That's what I figured, wanted to double check.

One down, one to go.

[ads]

Did you forget about the wss? Pretty sure the black 3 pin is your wss same as in the first post, the only non shielded 3-pin in that area of the engine bay from what I remember

[PRY4SNO]

Hmmm

Ill track that down first thing after work.

[PRY4SNO]

The unshielded one is directly from the engine harness.

Vss is plugged directly at the firewall.