pilihp2 wrote:You shortening the housing or adding a spacer? Hoping to do the race struts in the front before racing season starts up again this year. (I totally am gonna push it off till the last minute and not do it till next winter)
I'm going with spacers for the sake of simplicity. I'm not going super low anyways, but I may revisit shortening sometime down the line. I assume you're shortening, but if not, I can send you the drawings for the adapters if you're interested.
Kevin (Sven) - 1991 200 20vt K24-7400 AAN - 1991 200 20vt Avant K24-7400 VEMS - 1992 Audi V8 5-speed swap + ABZ - 2002 Audi S8 6-speed swap - 1979 Audi Fox quattro 20vt - 2003 RS6 6mt Stage 2
Aktapod wrote:Loxx is pretty busy these days. I've taken over the project temporarily and will be field testing the prototypes very soon on the T44 and D11 platforms. I'll be test fitting with Koni Sport (86 2149), Koni Race (8610-1437), and Bilstein Sport (34-003695) struts. The strut mounts are currently out being zinc plated, and I'm awaiting a few small sleeves to be machined by my friend.
Sorry for the wait, but they haven't been forgotten! Will update soon, hopefully
Guess I am old school until I can figure out what to assemble. I just started working on this again after 6 years of sitting. Sprayed every nut and bolt with pb blaster in preparation for the weekend project. I am looking forward to seeing how this progresses and hopefully be part of a group buy!
It's about time I update this! I got the parts back from zinc plating and am working towards test fitting on the 200. Preliminary fitment looks very good for all tested damper configurations. The car should be back on the road this week, and I'll take it to an alignment shop to see what the full adjustment range looks like.
Kevin (Sven) - 1991 200 20vt K24-7400 AAN - 1991 200 20vt Avant K24-7400 VEMS - 1992 Audi V8 5-speed swap + ABZ - 2002 Audi S8 6-speed swap - 1979 Audi Fox quattro 20vt - 2003 RS6 6mt Stage 2
