The Project Pad

What is everyone using for a replacement intake air sensor 034 905 379B?

thanks!

if you go vems, you can use 1.8T or https://shop.vems.hu/catalog/sensor-p-115.html

Good option, thank you, I was hoping for something that did not require modifying the manifold.

FFF wrote:Good option, thank you, I was hoping for something that did not require modifying the manifold.

The 1.8T is not a direct replacement. The hole has to be enlarged on the manifold.

I'm running the 1.8T sensor, it sticks up pretty high!

Thanks, I’m using a Wagner so it is on the front rather than the top.


Sent from my iPad using Tapatalk Pro

type85 wrote:I'm running the 1.8T sensor, it sticks up pretty high!

Did you have to modify the bolt hole that holds the temp sensor in or do you use the factory hole?

Thanks!

FFF wrote:

type85 wrote:I'm running the 1.8T sensor, it sticks up pretty high!

Did you have to modify the bolt hole that holds the temp sensor in or do you use the factory hole?

Thanks!

Yes, I had to drill out the manifold, then used gasket sealer to make sure there wasn't a vacuum leak, I think the connector is different as well....

Ok thanks.


Sent from my iPhone using Tapatalk Pro